Ring Size Guide

How to measure your ring size based on your existing rings

Measuring ring size using the inner diameter of an existing ring is a simple and effective method. Here are the steps to measure your ring size using the inner diameter:

Materials Needed:

  • An existing ring that fits comfortably on the finger you plan to wear the new ring.

Steps:

  1. Measure the Inner Diameter:

    • Take the chosen ring and place it on a flat surface with the inside facing up.
    • Measure the inner diameter of the ring from one side to the other, across the centre.

  2. Convert to Ring Size:

    • Use the following chart to determine your ring size based on the measured inner diameter.

 

 

How to measure your ring size based on your finger circumference

  1. Step 1: Gather Materials
    You’ll need a thin strip of paper, a pen, and a ruler. Alternatively, you can use a flexible measuring tape.

  2. Step 2: Wrap the Paper Around Your Finger
    Take the strip of paper or measuring tape and wrap it around the base of the finger you plan to wear the ring on. Make sure the paper is snug but not too tight.

  3. Step 3: Mark the Paper
    Use a pen to mark where the paper overlaps. This will give you the circumference of your finger.

  4. Step 4: Measure the Paper
    Lay the paper flat and use a ruler to measure the length from the start of the paper to the mark. This measurement is the circumference of your finger.

  5. Step 5: Find Your Size
    Use the following chart to determine your ring size based on the circumference: